[Feature Request] notification when no pin is set on the lock

[soana]

After the upgrade to v0.1.2 the two Kwikset 914 locks conected with this app lost the pin setup.
While I cannot say for sure it's because of the update or other things I did after the update I would like to have a feature that can notify if no pin is setup on any of the locks.

[tykeal]

@soana what version did you upgrade from? You shouldn't have lost any PINs. The only time I've personally seen that was an upgrade from v0.0.99 -> v0.1.x when there were either a lot of locks or a large number of PINs. Any update from v0.1.x -> v0.1.x shouldn't be losing PINs at all.

[soana]

It was a v0.1.x but it is possible I might have wiped them off without realizing. This is why I thought it would be nice to have a way to get a notification for somone as clumsy as me 😀.
Either way I will always double check my work after I tinker with any settings in keymaster.
Also this is in no way a complaint just wanted to share here that it took me about 2 hours of hardware debuging with A to B replacements to finally figure out why my keypad was flashing red when pushing the lock button but the lock will work just fine over z-wave. Duh Kwikset was like no pin no lock 🤔

[firstof9]

Pretty sure the lock emits some kind of notification via zwave, you'd have to setup the listener to see what it was squawking on zwave.