From 4eedd3983610e8b25816f2b1f1090bfa5bb6435f Mon Sep 17 00:00:00 2001 From: awujek Date: Mon, 21 Dec 2020 03:55:22 +0100 Subject: [PATCH] Update Sonoff_ZBBridge.md Update Flashing info with the hint about connecting Z_RST to GND. --- _zigbee/Sonoff_ZBBridge.md | 2 ++ 1 file changed, 2 insertions(+) diff --git a/_zigbee/Sonoff_ZBBridge.md b/_zigbee/Sonoff_ZBBridge.md index 8c24d4920..934801cce 100644 --- a/_zigbee/Sonoff_ZBBridge.md +++ b/_zigbee/Sonoff_ZBBridge.md @@ -27,6 +27,8 @@ Remove the 4 rubber feet to access screws and disassemble the device. Take out t |GND | GND |3v3 | 3V3/VCC +Note: If your USB to TTL converter cannot provide enough power, you can turn off the Zigbee module by to connecing Z_RST to GND. + Download [tasmota-zbbridge](https://github.com/arendst/Tasmota/blob/firmware/firmware/tasmota/tasmota-zbbridge.bin?raw=true), a unique binary built specifically for ZBBridge and flash it using your favorite flashing software. When the ZbBridge is flashed with Tasmota, **disconnect all breadboard wires** and power the board using its USB port with a 5V 1A power supply. Configure Wi-Fi [over Tasmota AP](https://tasmota.github.io/docs/Getting-Started/#using-web-ui) (you cannot configure the device over serial with this binary). After it is connected to your network access the webUI again.