limits on spot size x and y of the machine in the GUI

[happylulux]

hello, i'm trying rayforge 1.0 on windows 10 and i can't set properly all parameters of the machine by the gui.
The "spot size X" and "Y" seems to be set at 0.2mm max, i need a spot size of 0.55mm and i can't set it correctly.

Also i would like to know if it's possible to remove the limitation about going in negative value in x and y axis? i don't have limit switch on the machine(no homing then) and i would like to run the machine from where it as been turned on (usually approximately at the center of the working area)

Sorry if this is not the good format for the question, it's my first time on github

[knipknap]

Oh, I see. I will increase the limit for the next release (1.0.3 or 1.1).