ChangeCurrentSlider increase faster than decrease

[guillo7]

When I use the encoder with the ChangeCurrentSlider command, increasing the value increases it by 0.33 increments and decreasing it by 0.10 increments. Have I made a mistake in my settings, or is this a bug?
Thanks for your help!

[antzpantz]

I'd say it's your settings and/or controller configuration.

…

On Sat, 27 Dec 2025, 3:45 pm guillo7, ***@***.***> wrote: When I use the encoder with the ChangeCurrentSlider command, increasing the value increases it by 0.33 increments and decreasing it by 0.10 increments. Have I made a mistake in my settings, or is this a bug? Thanks for your help! — Reply to this email directly, view it on GitHub <#859>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AFIYPFA5L565SZ6L2KATB334DY2INAVCNFSM6AAAAACQDLY7NGVHI2DSMVQWIX3LMV43ERDJONRXK43TNFXW4OZZGI4DKNJVHE> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[guillo7]

Thanks for your reply. I tried setting a different parameter like "exposure" on this encoder and didn't encounter the same problem. However, I reset all the settings in the "Other..." tab of the settings window, and the problem remains the same for "Changecurrentslider" (+0.33 vs -0.10).

[antzpantz]

Look into your specific MIDI Controller's configuration which is separate to MIDI2LR settings.

…

On Mon, 29 Dec 2025, 4:53 am guillo7, ***@***.***> wrote: Thanks for your reply. I tried setting a different parameter like "exposure" on this encoder and didn't encounter the same problem. However, I reset all the settings in the "Other..." tab of the settings window, and the problem remains the same for "Changecurrentslider" (+0.33 vs -0.10). — Reply to this email directly, view it on GitHub <#859 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AFIYPFFY2RTZ7WFUXGMIZMT4EA7LDAVCNFSM6AAAAACQDLY7NGVHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTKMZVHA2DQMI> . You are receiving this because you commented.Message ID: ***@***.***>

[guillo7]

Thanks for the suggestion. The settings are the same for all controllers in the Behringer software. And on the same controller, if I assign a different function such as exposure, I don't get the same behavior.