Sequent 4 input 4 relay board not showing up on I2C after power surge

[Telemachus1977]

Neighborhood power went out, and my friends njs-PC set up took a hit.

SD card got corrupted, so that has been replaced and a backup installed.

However, the sequent 4 relay 4 input board no longer shows up on the I2C list. I can see the ADC, and each of the atlas probes.

The RS485 connection on the missing board is still working fine, as is the 5 volt input powering the raspberry pi.

Any suggestions for getting this thing to show up? Or is there a possibility it is fried?

†***********

Never mind, I scaned the I2C bus and was able to find it, it just wasn't showing up on the auto scan.