Extra Intelliflow Pumps showing in dashpanel that I cannot delete

[loopy321]

After updating from v. 6, I see extra pumps showing up that were not there before (I only have one intelliflow) and I cannot delete them via the config. Any ideas how to troubleshoot/fix? (See below, and I have attached a replay of the deleting which does not work). Thanks!!

replay (pump deletes).zip

[rstrouse]

I'll have a look. I have seen this with IntelliTouch where the panel was reporting all 8 slots but I haven't seen it in EasyTouch. They turned something off on the panel and it went away. When 8 pumps are involved, there is waaaaay more traffic on the RS485 bus. If we can make EasyTouch stop reporting these, your system may feel more responsive.

[loopy321]

Thanks! Not sure if it helps, but prior to the update, I believe it only showed the one pump.

[rstrouse]

Thanks. Good info to know.

[loopy321]

In case it helps I did a grep of my logfile for "pump" which includes prior to the upgrade change on 2022-03-21, but I could not figure out what happened differently. See attached.
Log-grep-pump_across-update-on-2022-03-21.txt

[rstrouse]

I figured it out. It turns out that older firmwares assumed that the pump types were populated with 255 for all 16 slots. Even though EasyTouch only allows 2 pumps it still reports 16 pumps but marks the type as 255. But the older firmware reports 255 as a VS3050 pump. I will have a fix shortly as the code just needs to detect the condition where the pump number is greater than the max available pumps.

[rstrouse]

Go ahead and pull njsPC. It may clean them up on its own or you may need to go in and delete them.

[loopy321]

Pulled and restarted, pumps still there, but deleted the extra pumps and hard refresh on dashpanel. Now all is well.
Awesome! Thank you for the help.