Conversation
This allows bm apps to run without a bristlefin
Creates the power info timing service in the bridge power controller Reports timing information for: - Initial time of bridge (two minute initialization period) - Bridge power controller with no subsampling - Bridge power controller with subsampling - Bridge power controller disabled
* add the ranges of the DO measurements to the bridge so we report NAN's when we are outside of the range * also fix the turbidity sensor to have the ranges
… To 1M(#273) Handshaking taken care of in GPIO ISR rather than UART RX 1M set as top baud rate rather than 921600.
…e needed (more testing needed), PFM bit is being cleared also.
… voltage and current
…the spotter instead of the VLSNS reading used earlier.
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
4 participants
Add this suggestion to a batch that can be applied as a single commit.This suggestion is invalid because no changes were made to the code.Suggestions cannot be applied while the pull request is closed.Suggestions cannot be applied while viewing a subset of changes.Only one suggestion per line can be applied in a batch.Add this suggestion to a batch that can be applied as a single commit.Applying suggestions on deleted lines is not supported.You must change the existing code in this line in order to create a valid suggestion.Outdated suggestions cannot be applied.This suggestion has been applied or marked resolved.Suggestions cannot be applied from pending reviews.Suggestions cannot be applied on multi-line comments.Suggestions cannot be applied while the pull request is queued to merge.Suggestion cannot be applied right now. Please check back later.
What changed?
Adding support for the ARPA-E + UPitt board which increases peak power available at a bristlemouth load on the bus.
How does it make Bristlemouth better?
Higher power!
Where should reviewers focus?
Checklist